Messages

1

Help / Blue Spray Won't Control Sprinklers in internet mode only standalone

« on: September 03, 2015, 03:21:15 pm »

I have been using my BlueSpray for several months without issue.  Two days ago, I couldn't see that my sprinklers would come on while I was logged into the unit via the internet when I selected a manual run or see that when I ran my programs nothing showed and the sprinkler zones didn't run.  I made the mistake of placing the unit in standalone mode to test it.  While I can now operate my sprinklers only in standalone mode and the programs I have run fine, I can't get my unit out of the standalone mode.  I have written BlueSpray without any response.  When I select internet in the system setting and select an access points SSID and key and set the login to require a password which I enter, the moment I select the enter key to set the settings, the controller returns to standalone mode with no encryption.  Please help me.  I really need to use this and not have to use it in standalone mode.  I would appreciate a phone call ASAP. 

2

Help / No hole in case for rain sensor cable or power supply wire to connect.

« on: April 09, 2015, 01:14:34 pm »

I am working to install my BlueSpray controller but the wiring from the various zones comes up through a conduit which was connected to my Hunter 24 Zone Controller.  The rain sensor wire ran through a hole on the top of the Hunter case but there is no hole to run the cable into the case on the bottom to wire the sensor. There was also a hole for the power cable to enter the controller case.  It appears I will need to drill a hole on the bottom of the case to run both sets of wires. Am I correct or do you have another suggestion?