1
Help / Re: Entered wrong server info now cannot access
« on: June 29, 2015, 08:21:33 am »
20 seconds was the trick....Thanks for the great customer support!!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Help / Re: Entered wrong server info now cannot access
« on: June 28, 2015, 05:58:16 pm »
decided to upgrade to the bluespray to be able to access from iphone anywhere and now I cannot even water the yard and not even a phone number to speak with a human for support?? Really?
3
Help / Re: Local Image
« on: June 28, 2015, 05:51:30 pm »
It must be hosted on a site to be accessed by bluespray. 
4
Help / Entered wrong server info now cannot access
« on: June 28, 2015, 05:41:46 pm »
Ok so the instructions were not clear in the box on setup and when I connected to the bluespray network I entered the incorrect information for the server. Actually I did not enter anything and did not set up a username or a password. Now I am trying to access the controller again through the bluespray network after resetting it several times by moving the switch down for 15 seconds then back up. When I rejoin the bluespray network and enter the 192.168.1.1 local URL it asks for a username and password which I did not set up so I cannot access it and am not able to get it to reset to factory. Please advise. Hopefully once connected I can forward the ports to access from outside home network but the most important thing for me is to upgrade to the new firmware to be able to add a station delay for my well water to recharge and have enough pressure to run.
Pages: [1]