Show Posts
1
Help / Master Valve on-off for individual zones
« on: July 09, 2017, 04:26:35 pm »
Is there a way to have the master valve not go on for a single zone within a program? I would have expected a MV setting for each zone.
I could wire in a relay for that particular zone to disconnect MV power if I had to, but I'd rather not.
I pump pond water, and every other zone is a filter backwash cycle. I can't have the pump on for this cycle.
I'm switching from a Rainbird controller with this capability because I want internet - network control.
Thanks,
Frank
I could wire in a relay for that particular zone to disconnect MV power if I had to, but I'd rather not.
I pump pond water, and every other zone is a filter backwash cycle. I can't have the pump on for this cycle.
I'm switching from a Rainbird controller with this capability because I want internet - network control.
Thanks,
Frank